Sway bars are used on tandem campers only. If your camper requires these, this is the first part to disconnect when at the park.
Leveling wedge and chocks. Before unhitching, the wedge block is used to level horizontally by backing up on the wedge (one wheel on the low side), and chocks are used on the other side, one set for single axels 2 sets for tandem. Then, the hitch used the jack to level the long way, as indicated by the bubbles.
Stabilizer block. One stabilizer in each corner of the camper, use the cracks to set and block when needed.
When 1-3 is done, connect the black water hose and set up the hose support using the supplied fitting. There is a 20’ hose. Support needs to be downgraded from camper,
Electrical 1st plug in the surge protector, wait for the diagnosis, when confirmed, then plug in the short line. From time to time, there are problems in the campsite. Extra converters are supplied when needed.
Water, supplied 1st hook up, the pressure control must not be set no higher than 45 lbs. Open the valve to clear the air.2nd, connect the hose. 3rd 90 ° fitting to the camper. 4th. 6inch flex hose, 5th. Water filter, then water line. Be sure all faucets or valves are closed. Then turn the water on, fill the water heater, open all faucets one at a time till all air has been removed.
Supplies you will need: can liners, toilet paper for campers, paper towels, black water treatment, a must-know-how, and be used. Or the black tank may plug, and you may not be able to dump.
Matters pads, moisture-resistant,(mandatory), these are supplied at a cost, or you can purchase your own. Either way, they go home with you.
These containers are for storing hose and all other items when the camp is broken down, sewer in one, and fresh water in the other.
Jack has been supplied with the proper tool to remove a lug nut in the event of a flat tire. Don’t want to see your vacation held up.
